The Rosenquist Model EG-1000-H is a feed thru, high quality, high production, radio frequency edge laminating and assembly press
The press is mounted at a 40-degree angle for ease of loading
The top platen will open 70 degrees from the bottom platen for ease of access to the press area
Gluing Capacity: 120" long x 48" wide x 2.5" thick
Self-contained Rosenquist 20 KW generator will efficiently cure approximately 2,000 square inches of glue line per minute of cure time
In-Feed Lay-up Table 132" Long x 53" Wide, will tilt to Align with the Press or Lay Flat on a Horizontal Plane
Out-Feed Table 126" Long x 48" Wide with a Tilt Down Device Similar to the In-Feed
Side Pressure: 20 Individual Hydraulic Cylinder 1.5" Bore x 24" Stroke
Top Pressure: 5 Hydraulic Cylinders 2" Bore
Hydraulic Pump Unit with 15HP Motor Powers a 20 GPM Pump
Pre-Clamping Feature Allowing the Operator to Apply Reduced Pressure to the Product While the Top Platen is in the Open Position
Smart Cure will Automatically End the Cure Cycle Once the Adhesive is Set
Automatic Power Control Eliminates the Need to Adjust Power Control Manually
Programmable Cylinder Selection: The Control System is Equipped with a Interface Module that will Allow the Operator to Select Which Edge Pressure Cylinders will be Active to Clamp the Next Door from the Operators Control Panel
Currently Wired for 480 Volt Power. Incoming Amps: 121
Upgrades Included:
Light Curtain with Safety Relay across the front of the machine
