Presses - Radio Frequency

Used Rosenquist Model EG-1000-H Inclined Radio Frequency Edge Gluer

Stock #1386 - Available (Cleaned and Checked)



  • The Rosenquist Model EG-1000-H is a feed thru, high quality, high production, radio frequency edge laminating and assembly press
  • The press is mounted at a 40-degree angle for ease of loading
  • The top platen will open 70 degrees from the bottom platen for ease of access to the press area
  • Gluing Capacity: 120" long x 48" wide x 2.5" thick
  • Self-contained Rosenquist 20 KW generator will efficiently cure approximately 2,000 square inches of glue line per minute of cure time
  • In-Feed Lay-up Table 132" Long x 53" Wide, will tilt to Align with the Press or Lay Flat on a Horizontal Plane
  • Out-Feed Table 126" Long x 48" Wide with a Tilt Down Device Similar to the In-Feed
  • Side Pressure: 20 Individual Hydraulic Cylinder 1.5" Bore x 24" Stroke
  • Top Pressure: 5 Hydraulic Cylinders 2" Bore
  • Hydraulic Pump Unit with 15HP Motor Powers a 20 GPM Pump
  • Pre-Clamping Feature Allowing the Operator to Apply Reduced Pressure to the Product While the Top Platen is in the Open Position
  • Smart Cure will Automatically End the Cure Cycle Once the Adhesive is Set
  • Automatic Power Control Eliminates the Need to Adjust Power Control Manually
  • Programmable Cylinder Selection: The Control System is Equipped with a Interface Module that will Allow the Operator to Select Which Edge Pressure Cylinders will be Active to Clamp the Next Door from the Operators Control Panel
  • Upgrades Included:
  • Light Curtain with Safety Relay across the front of the machine
  • Redundant Plate Contactor
  • High / Low Power
  • Stack Light with Alarm
  • New Touch Screen
  • Delivery and Installation Included
  • Serial No. 1103-1277-22H

You may also be interested in