Cutting Capacity: 45°: 3½" X 3½" 90°: 2½" X 7"
45° compound: 1" X 7
75 PSI 5.2kg/cm2; 4 CFM at 75 PSI .11 cubic meters at 5.2 kg/cm2; based on 10 strokes per minute
Dust Ports: Four, 4" round 102mm outlets are provided, two for each saw head; 900 CFM required per saw head
10 strokes per minute; actual production rates will vary with type and width of material to be cut
Heavy gage steel; eight foot centers with traveling right hand carriage on rack and pinion
Completely encloses blade in rest position; lower rotating blade guard pivots up into main stationary blade guard as saw heads pivot down to cut
Tables are precision machined and ground iron castings with milled keyways in tables to guide fences
Saw heads swivel from 90° to 45° towards each other with degree markings and pointer; stops are at 90° and 45; phenolic chip breaker included
Saw head will compound angle cut up to 45° in direction shown with positive pin stops at 90°, 22-1/2°, and 45°; bottom of blades point towards each other; saw will also compound cut up to 10° on other side of vertical plane
Cutting Capacity :
90° Straight Cut; 2-1/2" 64mm High x 7" 178mm Wide
45° Mitre; 3-1/2" 89mm High x 3-1/2" 89mm Wide
90° Front to Back/45° Compound; 1" 25mm High x 7" 178mm Wide
