Weber Model KSN-36-1350 52" 3 Head Wide Belt Sander
Three sanding belts for calibrating, veneer and lacquer sanding. With constant pass-line 900 mm and in the following configuration:
Head 1 - Contact Roller Head with grooved steel contact roller Ø 210 mm for precise calibration, electrical adjustment of the contact roller for grain compensation, pressure bar guide of the workpieces
Head 2 - Contact Roller Head with grooved rubber contact roller Ø 300 mm, 60 Shore for absolutely precise calibration, electrical adjustment of the contact roller for grain compensation, pressure bar guide of the workpieces
Head 3 - CBF - Dual Action Head with grooved rubber contact roller Ø 130 mm, 60 Shore programme controlled adjustment and grain compensation of the contact roller (accuracy 0.1 mm), cross operating lamella belt with separate drive 4,0 kW, ISA segmented pad system with 22 mm panel scanning and 22 mm pressure piece width workpiece controlled sanding belt blow-off with oscillation
Operating width 52 in
Drive sanding head 1 (frequency controlled): 30 Hp
Drive sanding head 2 (frequency controlled): 25 Hp
Drive sanding head 3 (frequency controlled): 25 Hp
Drive feed: 2.6 Hp
Drive height adjustment: 1.7 Hp
Sanding belt speed: approx. 590 -3543 ft/min
Sanding belt dimension: 54 x 103 in
Panel thickness (min./max.): .157 – 7 in
Pass-line (constant): 35.4 in
Feed speed: 6.5 – 39 ft/min
Compressed air requirement: 80 PSI
Operating voltage:3PH/480/277VAC/GND 60 Hz
Control voltage: 24 V DC
Workpiece Cleaning and Vacuum Conveyor are optional at additional cost