Used US Concepts Model CHA-8 Hauncher

Stock #3143 - Available (Cleaned and Checked)

 

3143-1.jpg
3143-1.jpg
3143-2.jpg
3143-3.jpg
3143-4.jpg
3143-5.jpg
3143-6.jpg
3143-7.jpg
3143-8.jpg
3143-9.jpg
3143-10.jpg
3143-11.jpg
3143-12.jpg
3143-13.jpg
3143-14.jpg
3143-15.jpg
3143-16.jpg
3143-17.jpg
3143-18.jpg

  • The Hauncher is used to Make Shaped Cuts in the End of Along the Edge of a Board or Panel
  • Typical Uses Include Fingerjoint or Tenon Cuts on the Ends of Boards, Shaping the Edges of Square Ballisters, or Dental Mouldings, Notching the Edge of a Panel, or Shaping the End of a Moulding Such as a Window Aprons, etc.
  • Max. Tooling Width 8"
  • Maximum Working Height 5”
  • Maximum Cutting Depth 2”
  • Spindle Diameter 40 mm
  • Spindle Speed 6500 RPM
  • Cutter Diameter 8”
  • Feed Rates 0-21 FPM
  • Table Size 28” x 12”
  • Protractable Side Fence
  • Four (4) Pneumatic Hold Down Clamps Over Table
  • Pressure 90 PSI
  • Air Required for 8 Strokes Per Minute 3.5 CFM
  • Dust Collection Outlet 6”
  • Serial no. 2009832

You may also be interested in