The EBP 320 is our most basic edgebander that is a welcome addition in any small workshop. This highly compact unit (81 in. x 38 in.) is capable of handling 0.4 to 2 mm thick tape. Made for fast start-up with a quick-heating Teflon-coated glue pot, the machine delivers front-and-back as well as top-and-bottom trimming. The EBP 320 is available in both three and single-phase (at additional cost).
Panels are pulled by a steel-reinforced toothed belt over aligning rollers that help to keep the panel flush against fence during operation. The 1800 mm long work table is covered with scratch-resistant phenolic strips and there is a front extending support to help carry larger panels. Banding is cut from the coil via a pneumatic shear.
hree pressure rollers evenly apply the banding to the glued edge, and the front and rear edges of the banding are cut using a pneumatic end trim unit. The top-and-bottom flush trim unit has 75 mm cutters (with disposable knives) that offer a straight / 2 mm radius / 15° bevel. The flush trim unit also includes 120 mm scratch-resistant vertical disc copiers that are ideal for delicate finishes.
An optional mobility kit with caster wheel and t-handle provides the flexibility to store the unit out of the way when not in use.
Feed Speed: 7 m/min
Panel Thickness: 10mm-45mm
Edge Thickness in Coil on Panel: 0.4mm-2mm
Flush Trimming Motor: .37kW
Minimum Panel Length (Side Being Processed) : 220mm
Minimum Panel Width: 110mm
Compressed Air Operating Pressure : 6.5 Bar
Compressed Air Consumption During Operation : 90NL/min
Dust Extraction Outlet Connections: 120mm
Minimum Airflow at Dust Extraction Ports : 20m/s
Air Consumption of Dust Extraction System: 850 m3/hr