Used Putsch 980 PM Edgebander with Pre Mill

Stock #25903 - Available (Cleaned and Checked)

 

25903-1.jpg
25903-1.jpg
25903-2.jpg
25903-3.jpg
25903-4.jpg
25903-5.jpg
25903-6.jpg
25903-7.jpg
25903-8.jpg
25903-9.jpg
25903-10.jpg
25903-11.jpg
25903-12.jpg
25903-13.jpg
25903-14.jpg
25903-15.jpg
25903-16.jpg
25903-17.jpg
25903-18.jpg
25903-19.jpg
25903-20.jpg
25903-21.jpg
25903-22.jpg
25903-23.jpg
25903-24.jpg
25903-25.jpg
25903-26.jpg
25903-27.jpg
25903-28.jpg

  • Two-Motor Pre-Milling Unit
  • EVA Hot Melt Glue Pot
  • Pneumatic Guillotine
  • Three-Roll Pressure Section
  • Single-Motor End Trim
  • Top & Bottom Trim
  • Push-Button Operator Control Panel
  • Coil Feed Unit
  • Rubber-Padded Feed Chain w/ Overhead Idle Rolls
  • Feed Motor: .75/.9 HP
  • Feed Speed: 11 m/min
  • Panel Thickness: 8 - 60mm
  • Edge Thickness (Coils): 3mm
  • Minimum Panel Length: 120mm
  • Minimum Panel Width: 110mm
  • Sound/Safety Enclosure
  • Year: 2018
  • 230v, 3ph
  • Serial #: 18.861.001

You may also be interested in