New Giben Model KG 486JK Edgebander with Pre-Milling

Stock #251600N - Available (New)

 

KG 486JK.jpg
KG 486JK.jpg
KG 486JK.2.png
KG 486JK.3png.png

  • Touch screen
  • Support bar at 700 mm extractable
  • Chain drag with manual lubrication of the sliding guides
  • Speeds 10-15-20 m/min
  • Feed direction is left to right
  • Maximum panel height 60 mm
  • Maximum edge thickness 3 mm (laminate strips up to 3 mm if fed by hand)
  • Minimum length is 120 mm
  • Minimum width 80 mm
  • Voltage 220 / 480
  • Edge cutting and loading
  • Pre-milling
  • Pre-melt gluing with quick-change glue pot
  • Gluing unit and pressing roller
  • End cutting unit two position pneumatic adjustment (straight and angle)
  • Top & bottom trimming unit
  • Top & bottom fine trimming unit
  • Four motor corner rounding
  • Profile scraper with pneumatic control
  • Flat scraper
  • Double buffing unit with pneumatic control
  • Speed 20-23-26
  • Pneumatic set up for quick change from thin tape to 2 - 3mm
    Available options for KG edge banders
  • Strip feeder
  • Flat or profile scraper
  • Diamond tooling (2 or 3 mm)
  • Upgrade premill to 65mm
  • Hot air blowers
  • Additional glue pot (quick melt)
  • Additional glue pot (non quick melt)
  • Reverse feed
  • Transformer

You may also be interested in