13" Vertical frame and notching saw The Model N80 is used for a variety of cutting applications including 45° double mitre cutting, notching and bending of aluminum and plastic extrusions, or toe-notching of wood panels. This heavy duty machine can have blades set for notching or mitering. Blades move vertically on linear bearings on 1" (25mm) hardened and ground rods. Keyed fences allow for each set-up and accurate dimensional changes.
Blade Capacity 13" OD (330mm); saw blades not included.
Arbor 1" (25mm) with 3" (76mm) saw collars; mounted on preloaded and sealed bearings; 2-belt drive; 3450 RPM of spindle.
Motors & Voltages Two, 2 H.P. 3 Phase 230/460 Volt Totally Enclosed Fan Cooled Motors, 60 Hz, 3450 RPM with Dual Magnetic Starter; 3 H.P. Motors available.
Table Base Precision machined and ground iron castings with milled keyways to guide fences; allows for easy and accurate dimensional changes.
Floor Stand Heavy gage steel; stand is completely enclosed with 6" (152mm) dust collector outlet and scrap chute; 1200 CFM required.
Actuation Air operated by foot valve with cover.
Air Pressure & Consumption 3 CFM at 80 PSI (.09 cubic meters/minute at 5.6 kg/cm2) based on 10 strokes per minute; includes air filter/ regulator/lubricator with auto drain.
Size & Weight 43" (109cm) Wide x 38" (97cm) front to back x 58" (147cm) High; Weight 750 lbs. (340kg).
Production Rate Up to 15 strokes per minute.
Cutting Capacity Staggered Saw Blades/ Toe-Notch Configuration; 4-1/2" (114mm) x 4-1/2" (114mm) Deep x 3" (76mm) High Mitre Cutting/Staggered Saw Blades; 3-1/2" (89mm) Wide x 3" (76mm) High Mitre Configuration/Non-Staggered Saw Blades; 3-3/8" (86mm) Wide x 3" (76mm) High; up to 5" (127mm) High with special blade guard modification at extra charge.