Used Cameron Automation Model 34G-M1 Quick-Rip Gang Rip Infeed System

Stock #8692 - Sold (Cleaned and Checked)

 

8692c.jpg
8692c.jpg
8692.jpg
8692b.jpg
8692d.jpg
8692e.jpg
8692f.jpg
8692g.jpg
8692h.jpg
8692j.jpg
8692k.jpg
8692l.jpg
8692m.jpg
8692n.jpg
8692o.jpg
8692p.jpg

  • Fence-Less Gang Rip Saw Optimizer
  • Five Lateral Feed Belts Accelerate the Board past Several Sensors which Measure the Profile Every Foot for the Length of the Board
  • Belts then Position the Board Under the Laser Lights, which Mimick the Arbor Set-Up on the Rip Saw
  • Operator is Presented with the Optimum Rip Combination Based on the Boardís Measurements
  • Operator is Able to Over-Ride the Computerís Chosen Cut (Positioning or Skew)
  • Pinch Rollers Feed the Board into the Saw
  • Single Operator Loads and Defects
  • Can feed 8-10+ Boards/Minute
  • Small Footprint
  • Easy-To-Use Softward Designed and Programmed By Cameron
  • Five Rubber Lateral Feed Belts
  • One Driven Top Pinch Roll (3/4 HP Motor)
  • Top & Bottom Idle Rollers
  • 220v, 3ph
  • Push-Button Controls
  • 2005 Machine
  • Serial #: OR-174

You may also be interested in