New SCM Sandya 300 RCS 95 37 Two Hd. Wide Belt Sander

Stock #7003N - Available (New)

 

7003N.jpg
7003N.jpg

  • Rubber coated pressing rollers before and after working unit for part hold down
  • 1 HP variable speed feed unit
  • Feed speeds set at 10 to 60 feet per minute
  • Pneumatic exclusion of working units from front control panel
  • Y-Delta two-stage reduced voltage starter on main motor
  • 2 roller Infeed and outfeed table extensions for additional part support
  • Automatic Electronic Table Positioning Device for fast set-ups
  • Electronic digital thickness readout of work table position
  • Powered table lifting by means of four heavy duty motor and lifting columns double fastened at both top and bottom of the lifting columns to provide exceptional table stability
  • Electronic tracking of abrasive belt
  • Automatic feed mat tracking
  • Pneumatic belt tensioning with center fulcrum to compensate for tapering of abrasive belt
  • Front and rear emergency stop buttons
  • Automatic emergency stop of machine for: - sanding belt breaking, tensioning, overtracking - opening of the access door to the operating groups - absence of compressed air - overload on main motors
  • Amperage meter for main motors allows maximum utilization of available horsepower
  • Main disconnect switch with the ability to be locked out by padlock
  • In feed flexible steel hold down, and anti kick back plate
  • 50 shore, negative profile (waffle style) rubber feed mat
  • LOGIC 50 K Electronic Programmer for timing/anti-dubbing of the pad
  • Working Width: 950mm (37)
  • Number of Heads Available: 2
  • Feed Motor: 1 HP
  • Maximum Work piece Thickness: 170mm (6.69)
  • Minimum Work piece Length: 12.5 inches
  • Abrasive Belt Size: 37 X 75
  • Compressed Air Requirements: 6 Bar (88 PSI.)
  • Dust Outlets: 2 outlets @ 140mm (5.5)
  • Exhaust Requirements: 1800 CFM
  • Power Requirements: 80 amps @ 230 Volts/3 phase
  • 1st Working Unit: Motor Hp: 30 hp (shared)
  • Motor Type: Single Speed
  • Abrasive Belt Speed: 18 MPS
  • Drum Size: 120 mm (4.75)
  • Drum Type: Steel
  • Abrasive Belt Length: 75
  • 2nd Working Unit: Motor Hp: 30 HP (shared)
  • Motor Type: Single Speed
  • Abrasive Belt Speed: 18 MPS
  • Drum Size: 120 mm (4.75)
  • Drum Type: 45 Sh Rubber
  • Platen Size: 50m (2)
  • Platens Included: Two
  • Abrasive Belt Length: 75

You may also be interested in