New SCM SI 300S NOVA Sliding Table Saw

Stock #9106N - Available (New)

 

9106.jpg
9106.jpg

  • The SI 300S is a short stroke sliding table saw and is commonly used for cutting smaller components
  • The sliding table can be locked into position and the saw may also be used for ripping large panels
  • Both large and small shops can benefit from this versatile performer
  • The double trunion assembly for the blade tilting is part of the blade group casting
  • This eliminates the possibility of misalignment which exists when these parts are bolted in the place as some manufacturers do
  • Others used a small pivot pin to hold up the saw group.
  • Direct shaft drive coupled with rack and pinion gearing allow smooth, angle adjustment of the saw blade
  • Adjusting the scoring set is quick and easy
  • Simply turn the dial to adjust the width of the score
  • This system eliminates the need for shims and the constant adjustment they require
  • It is fully adjustable in 0.1mm increments
  • Compact squaring frame support with fence, Anodized aluminum alloy carriage sliding on “v style” hardened steel guides
  • Manual lifting and tilt of saw unit by means of handwheels on the machine front side
  • Mechanical readout of tilt (0 - 45 degrees) on the machine front side
  • Blade protection on riving knife with exhaust outlet
  • Squaring frame complete with mobile aluminum bar for quick setup for angular cuts
  • Heavy duty crosscut fence with flip stops
  • Control panel on the machine front side tilted 25 degrees for easy access
  • Scoring unit with external setup and stops for a quick re-positioning of the blade
  • “EZ Dial” Adjustment for the split scoring blade
  • Scoring unit powered by independent motor
  • Rip fence with micrometric adjustment
  • Eccentric clamp
  • Table extension on exit side
  • Overload switch protection Auxiliary low voltage circuit (110 voltage)
  • Direct start main motor
  • Motor horsepower:(Main/Scoring) 9 HP / 1 HP
  • Scoring Motor Horsepower: 1 HP
  • Fixed table size: 31” x 36.4”
  • Sliding table size: 12” x 61”
  • Height of worktable: 33.5”
  • Rip capacity: 1270mm (50”)
  • Max. length of crosscut with scoring: 1600mm (62.9”)
  • Main blade diameter/arbor: 315mm/1”
  • Scoring blade diameter/arbor: 120mm/3/4"”
  • Arbor speed -main/scoring: 4,800/9,600RPM
  • Dust outlets - main/overarm guard: 120mm/65mm (4”/2.5”)
  • Depth of cut: - 0 degrees/45 degrees 100mm/70mm(3.9”/2.75”)
  • Electrical requirements: 21 amps @ 230 volts, 3phase Dust extraction: 850CFM

Additional Machine Information
- SCM Nova Circular Saws.pdf

You may also be interested in