Used GreCon Dimter Opticut S-50 Optimizing cut off saw

Stock #8040 - Available (As Is)

 

8040i-07.JPG
8040i-07.JPG
8040i-04.JPG
8040i-06.JPG
8040i-08.JPG
8040i-09.JPG
8040i-10.JPG
8040i-11.JPG
8040i-12.JPG
8040i-13.JPG
8040i-14.JPG
8040i-15.JPG
8040i-16.JPG
8040i-18.JPG
8040i-19.JPG
8040i-20.JPG
8040i-21.JPG
8040i-22.JPG
8040i-23.JPG
8040i-24.JPG
8040i-25.JPG
8040i-26.JPG
8040i-27.JPG
8040i-29.JPG
8040i-31.JPG
8040i-33.JPG

  • The Infeed System Consists of a Precision, Servo-Controlled Pusher Arm that Travels Along the Full Length of the Board, Measuring Length, Grade Zones and Defects
  • The Pusher Arm Automatically Positions Itself After Measuring the Board and Then Precisely Feeds the Board Into the Saw Unit
  • Board Length: 14' 9" Maximum
  • Board Thickness: 0.5" Minimum, 4" Maximum
  • Board Width: 3/4" Minimum, 12" Maximum
  • Board Cross Section: 13/16" x 7/16" minimum, 4" x 12" Maximum
  • Saw Blade Drive Motor: 9 Hp
  • Saw Blade Diameter: 500mm (20")with 35mm Bore
  • Saw Blade Speed: 2,400 RPM
  • Saw Unit Uses 2 Pneumatically Operated Side Hold Over Rollers Before and After the Saw Blade
  • A Computer Controlled Hold Down Pressure Shoe Assembly is also Used to Ensure that Boards are Securely Held in Position During the Cut Cycle
  • These Hold Down and Hold Over Devices and the Precision Servo Controlled Pusher Arm Provide a Square, Accurate, and High Quality Saw Cut
  • Infeed Table 21" x 19.5" with 4" High Fence
  • Outfeed Table 21" x 8' Long
  • Marking with Luminescent Crayon for Defects
  • Serial No. 1360.14

You may also be interested in